Logik LVD7W18 Problems
Logik LVD7W18 tumble dryers are renowned for their functionality, but, as with any appliance, users might face certain issues over time. One of the prominent problems experienced is the flashing of the drying and end lights, accompanied by a beeping sound, when initiating a drying cycle. If you’re battling with this or similar problems with your Logik dryer, this article sheds light on potential causes and solutions.
The Problem
Upon starting a cycle, the Logik LVD7W18 dryer starts flashing its drying and end lights while beeping simultaneously. This interrupts the cycle immediately. Even after ensuring cleanliness of essential components like lint, filter, sensor bars, and water drawer, the problem persists. While the door click and drum may seem fine, the flashing lights and halted cycle remain issues of concern.
Potential Causes & Solutions
- Heater Reset Thermostat:
- Some speculate the dryer might possess a heater reset thermostat, typically located under the main rear cover. Though not explicitly mentioned in all manuals, it’s crucial to check for its presence.
- If your unit is still under warranty, it’s vital not to tamper with it to avoid voiding the warranty.
- Warranty Concerns:
- A significant number of users advise checking the warranty before diving into any DIY fixes. For a device as young as six months, it’s likely still under warranty. Although there have been reports of challenges when dealing with certain retailers, persistence can often result in solutions.
- Fault Definition – Rear NTC or Wiring Open Circuit:
- This refers to potential issues with the NTC, one of the thermistors, or a thermostat. Some models, especially variations of the LVD7W18, do have a reset button on the overload stat.
- To access it, turn off the power, remove the heater or rear cover, and the heater should be directly visible. There will be two stats on top of the heater; the right one being the resettable stat. Gently press the button on the right stat. If it clicks, the circuit is reset, and the heater should function. If not, the issue might be more intricate.
- Potential Overloading:
- Excessive loading can cause the machine to overheat. If the air blown into the machine cannot circulate efficiently due to an overload, the machine may overheat, causing the stat to click out.
- Another related issue is the drum not rotating under load, which might indicate a failed capacitor, a faulty cycle stat, or a blocked condenser.
- Varied Model Versions:
- It’s essential to recognize that there are multiple versions of the Logik LVD7W18 model. This results in varied internal components, so always ensure you’re referring to the right model when seeking solutions.
When All Else Fails
If you’ve exhausted all the above options and are still facing the issue, it might be time to contact the store from which the dryer was purchased and speak to a manager. Ensure you have a clear understanding of your model’s specifics, as variations can lead to different troubleshooting methods.
Conclusion
While the Logik LVD7W18 is a valuable addition to many households, being prepared for potential issues ensures longevity and efficient functioning. Always prioritize safety and consult with professionals when in doubt about the troubleshooting process.
